1. Main components: 
( 1 ) SD Z-160 intermediate frequency power supply 
( 2 ) compensation capacitor and forging furnace table 
( 3 ) induction coil, guide rail and cover 
( 4 ) pneumatic feeding mechanism 
2 , maximum input power: 160KW 
3 , output oscillation frequency: 1-20KHZ 
. 4 , the input voltage: three-phase 380V 50 or 60HZ 
. 5 , duty cycle: 100% 
6 , the cooling water requirements: ≥ 0.2MPa, ≥30L / min 
7 , heating capacity ( KG / min ) 
( 1 ) Steel to 1000 ° C : 5.7KG 
( 2 ) copper to 700 ° C :8KG 
8 , Countertop size: length 1.6 m × width 0.7 m × height 0.89 m 
9 , forging furnace weight: 260KG 
10 , for steel, copper, aluminum and other rod or tube material continuous heating

 

   Including medium frequency power supply, compensation capacitor box and workbench, induction coil, feeding mechanism, etc. According to different application requirements, it may also include infrared thermometer, temperature controller and feeding, coiling equipment, etc. 

Features of medium frequency monolithic heating furnace:

 ( 1 ) Large frequency range from 1KHZ to 20KHZ , according to specific heating workpiece The diameter is chosen to the right frequency. 

( 2 ) When the medium frequency forging furnace is heated, the length of the induction coil is 500mm - 1m long, and at the same time, multiple materials are heated to ensure the heating effect; 

( 3 ) The intermediate frequency heating furnace adopts continuous heating mode, induction The load inside the circle is relatively balanced, overcoming the huge change in the actual heating power of the equipment caused by the huge load change when the single bar load increases from room temperature to 1100 ° C during the entire heating process, so that the entire continuous heating process The actual power of the equipment can be guaranteed to be more than 85% of the rated power value , and the equipment can be effectively utilized. 

( 4 ) When heating non-ferrous metals such as copper and aluminum, by properly designing the induction coil and capacitor, the actual power of the equipment can also reach more than 85% of the maximum power, and the heating capacity of 3.5KG/KW• hour is achieved when the copper is heated. 

( 5 ) Compared with the thyristor intermediate frequency power supply, it is not only small in size, but also easy to maintain, and can save 15 to 20%.

Main monolithic furnace specifications and heating capacity: