The RZS 431 electric furnace reducer is a two-stage worm gear reducer. The utility model has the advantages of small volume, large speed ratio, self-locking transmission, low noise, etc., and is equipped with a manual device, which is convenient for installation and debugging. It is mainly used for automatic dumping of medium frequency electric furnace and high temperature electric furnace, and realizes mechanization of casting. It plays an important role in ensuring casting quality, reducing labor intensity and improving productivity. It can also be used for automatic welding, automatic turning, automatic rotation of assembly line workpieces, etc. .
Installation of RZS electric furnace special reducer
1. The following preparations should be made before installation:
I. Remove the rust preventive oil applied;
II. Perform an external inspection:
III. Turn the handwheel of the reducer by hand to check if its worm gear is normal.
2. The gearbox should be installed on the fastened base. The installation should be easy to maintain. There is no corrosive gas and water vapor in the surrounding air.
3. The gearbox is supplied without oil. HJ-30 (GB443-64) mechanical oil must be added to the reducer housing before starting. The oil level of the lubricating oil is counted from the inner bottom of the gearbox. RZS-431 is about 150-160mm; RZS-231 is about 125mm
4. The metal casing of the electrical equipment of the gearbox should be well grounded.
RZS431 electric furnace special reducer performance parameters
Output shaft center height (mm)
Maximum torque on the output shaft (kg/m)
Output shaft revolutions (rev / min)
Time required for the output shaft to turn 90 degrees (seconds)
Output shaft maximum allowable idle angle (degrees)
Motor rated voltage (volts)
Motor frequency (Hz)
Motor rated power (kW)
Dimensions (length, width and height) (mm)
Installation size (length × width) (mm)